ZyXEL Communications MAX-200HW2, User Manual

Page: 51 / 150

Chapter 3 Tutorial
MAX-200HW2 Series User ’ s Guide
53
connection is successfully configured. If you cannot access the web site, check the
Troubleshooting section of this User's Guide.
3.2 Set Up a WiFi Network
An access point (AP) or wireless router is referred to as an “ AP ” and a computer with a
wireless network card or USB/PCI adapter is referred to as a “ wireless client ” here.
We use the M-302 utility screens as an example for the wireless client. The screens may vary
for different models.
3.2.1 Configuring the AP (Your ZyXEL Device)
Follow the steps below to configure the wireless settings on your ZyXEL Device.
1
Open the
Wireless LAN > General
screen in the ZyXEL Device ’ s web configurator.
Figure 16 Network > Wireless LAN > General
2 Make sure the Enable Wireless LAN check box is selected.
3 Enter
SSID_Example3
as the SSID and select a channel.
4 Set security mode to WPA-PSK and enter ThisismyWPA-PSKpre-sharedkey in the
Pre-Shared Key field. Click Apply .
5 Open the Status screen.Verify your wireless and wireless security settings under Device
Information .
SSID SSID_Example3
Channel 6
Security WPA-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)
802.11 mode IEEE 802.11b/g