Chapter 1 Introduction
LTE3316 Series User’s Guide
18
2
Press the WPS button for more than five seconds and release it. Press the WPS button on another WPS
enabled device within range of the Zyxel Device.
Note: You must activate WPS in the Zyxel Device and in another wireless device within two
minutes of each other.
Note: The Zyxel Device’s WPS is disabled by default for security reasons. To use this feature you
will need to enable WPS, for more information see
1.5.2.3 The Reset Button
If you forget your password or IP address, or you cannot access the Web Configurator, you will need to
use the physical
Reset
button to reload the factory-default configuration file. This means that you will
lose all configurations that you had previously saved, the password will be reset to
1234
and the IP
address will be reset to
192.168.1.1
.
Reseting the Zyxel Device to Factory-Default Settings
1
Press the
Reset
button on the rear panel for more than five seconds to set the Zyxel Device back to its
factory default configurations.
2
Wait until the Power LED turns on steady white. his means the Zyxel Device is ready for use.
Restarting or Rebooting the Zyxel Device
1
Press the
Reset button
on the rear panel for two seconds to restart/reboot the Zyxel Device.
2
Wait until the Power LED turns on steady white. This means the Zyxel Device is ready for use.
1.6 Wall Mounting
You may need screw anchors if mounting on a concrete or brick wall.
1
Select a position free of obstructions on a wall strong enough to hold the weight of the device.
2
Mark two holes on the wall at the appropriate distance apart for the screws.
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
Do not wall mount the Zyxel Device over a height of 2m.
Table 2 Wall Mounting Information
Distance between holes
100mm
M4 Screws
Two
Screw anchors (optional)
Two
Summary of Contents for LTE3316-M604
Page 12: ...12 PART I User s Guide...
Page 40: ...40 PART II Technical Reference...
