ZyXEL Communications ES-2108, User Manual, Page: 147 / 284

Chapter 19 Multicast
ES-2108 Series User’s Guide
147
Configure MVR IP multicast group address(es) in the Group Configuration screen. Click
Group Configuration in the MVR screen.
"
A port can belong to more than one multicast VLAN. However, IP multicast
group addresses in different multicast VLANs cannot overlap.
Figure 80 Advanced Application > Multicast > Multicast Setting > MVR > Group
Configuration
The following table describes the labels in this screen.
Table 47 Advanced Application > Multicast > Multicast Setting > MVR >Group Configuration
LABEL DESCRIPTION
Multicast
VLAN ID Select a multicast VLAN ID (that you configured in the MVR screen) from the drop-
down list box.
Name Enter a descriptive name for identification purposes.
Start Address Enter the starting IP multicast address of the multicast group in dotted decimal
notation.
Refer to
Section 19.1.1 on page 137 for more information on IP multicast addresses.
End Address Enter the ending IP multicast address of the multicast group in dotted decimal notation.
Enter the same IP address as the
Start Address field if you want to configure only one
IP address for a multicast group.
Refer to
Section 19.1.1 on page 137 for more information on IP multicast addresses.
Add Click Add to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to reset the fields.
MVLAN This field displays the multicast VLAN ID.
Name This field displays the descriptive name for this setting.
Start Address This field displays the starting IP address of the multicast group.
End Address This field displays the ending IP address of the multicast group.