ZXCBTS (V5.4) CDMA Micro Base Transceiver Station & Remote Station Installation Manual
5-4
Step 2: Strip the 17mm-long sheath off the four-core cable at the end to be welded. If
the sheath of more than 17mm is stripped, the component 3 cannot press the cable tight;
if less than 17mm, inconvenience might be caused for installation. See Fig. 5.3-2.
1
2
3
5
4
Fig. 5.3-2 Assembling a Power Cable Connector (step 2)
Step 3: Strip the 5mm-long insulation layer off the four core wires respectively, twist
up the copper core wires and brush a slice layer of soldering tin on them, and then put a
10~15mm-long heat-shrink tube onto each core wire.
Step 4: Joint the core wires respectively with the binding posts of the component 6 by
welding them, push the heat-shrink tubes to the proper position and then make them
shrink, as shown in Fig. 5.3-3. Refer to Table 5.1-1 for the corresponding relationship
between the core wires and the binding posts.
1
2
3
5
4
6
Fig. 5.3-3 Assembling a Power Cable Connector (step 4)
