22
DR300-UN
To Recall a Saved Bolt Array Feature:
Mill Functions
Step
Buttons
Information Screen
1 Press the array button to access the bolt array feature
2 Press 2 to load an existing bolt array program
Select the program you would like to load using the up
and down arrows, then press OK to confirm
3 The DRO will cycle through all of the setup parameters
Press OK for each if the information is correct
OR
Change the desired values using the numpad or the up
and down arrows
4 When the information screen reads BOLT ARRAY, the first
point is displayed. Move the X and Y axis until the axis
displays read zero
5 Plunge the tool to the desired depth
Retract the tool above the workpiece once the hole is
drilled
6 Press the up arrow to advance to the next point and
move the tool until the X and Y axis displays read zero
Repeat step 5
7 Repeat step 6 until all points are completed
When the program finishes, press cancel to exit the
program and 1 to confirm
**BOLT ARRAY**
1-New 2-Load
Terminate ?
1-Yes 2-No
Load
Bolt Array 01
***BOLT ARRAY***
Pt. 001 of 025
X Start Pt. (Abs)
0 in
Step
Buttons
Information Screen
6 Enter the distance between holes using the numpad
Press OK to confirm
7 Enter the number of lines using the numpad or the up
and down arrows
Press OK to confirm
8 Enter the distance between lines using the numpad
Press OK to confirm
9 Press 1 to save the program
Use the up and down arrows to choose a program slot
to save in and press OK
OR
Press 2 to run the program without saving
OR
***BOLT ARRAY***
1-Save 2-Run
***BOLT ARRAY***
Save As: 01
Number of Lines:
2
Dist Btwn Holes:
1.25 in
Dist Btwn Lines:
0.625 in
