21
Bolt Array
To automatically calculate the position of holes in a linear pattern, at any angle, use the Bolt Array function. It requires the
following inputs:
• The position of the starting point of the array
• The angle of the array (counterclockwise from the three o’ clock position)
• The number of holes to be drilled per line (up to 99)
• The distance between the holes on the lines
• The number of lines (1 to 9 lines are supported)
• The distance between the lines.
Bolt array can be used as a bolt line function if the number of lines is set to one. The Bolt Array feature can be saved to one
of 99 slots or it can be run immediately without saving
Mill Functions
To Create a New Bolt Array Feature:
X Start Point
Y Start Point
Array Angle
Distance Between Holes
Distance Between Lines
X Axis
Y Axis
Datum
Step
Buttons
Information Screen
1 Press the bolt array button to access the bolt array
feature
2 Press 1 to setup a new bolt array program
3 Enter the starting point of the array for each axis:
Press 1 to sense the current position
OR
Press 2 to enter the position using the numpad
Press OK to confirm
4 Enter the array angle using the numpad
Press OK to confirm
5 Enter the number of holes per line using the numpad or
the up and down arrows
Press OK to confirm
**BOLT CIRCLE**
1-New 2-Load
# Of Holes/Line:
05
OR
X Start Point
1-Sense 2-Enter
Array Angle:
0 Deg
