ZSC-1000 User Manual.doc
Issue 18
Page 37 of 46
M
E
Y
E
R
T
E
C
H
L
I
M
I
T
E
D
Z
S
C
-1
0
0
0
Remote reporting
It is possible to report alarms to a remote site (often used in central monitoring type scenarios)
Remote site
The site number of the target site for the alarm to be reported to.
A value of zero turns remote reporting off.
Default = 1
Trunk output
The output trunk used to pass the alarm video to the remote site.
Default = 1
Timings
A set of timeouts, in units of seconds, to control the automated functionality of the alarm handler.
A value of 0 disables the timer.
Accept time
The time after an alarm is accepted, before pool resources are automatically released.
Default = 5 seconds
Cancel time
The time after an alarm source clears itself, before it is automatically cancelled.
Default = 20 seconds
Postpone time
The time that an alarm is postponed for, before it is re-reported
Default = 5 minutes
Default event enabled
It is possible to set up a default alarm event that will be actioned if the raised alarm has not been defined.
The Default alarm event is event number 500. Note that device fail alarms are not handled by the default
event.
Default = off
Pass through
If pass through is enabled then alarms will not be handled by the ZSC-1000 but will be passed through to the
PC2 port.
Note
: only alarms that have been configured using the
Alarm
section will be passed through, however this
configuration will have no further effect.
Default = off
Cancel enable
Automatically cancels the alarm if the alarm source clears itself
Default = off
