ZSC-1000 User Manual.doc
Issue 18
Page 28 of 46
M
E
Y
E
R
T
E
C
H
L
I
M
I
T
E
D
Z
S
C
-1
0
0
0
Site Number / Trunk Index
Site number to remap cameras to or Index into Trunk Input table used for remote mapping on a specific
trunk. If re-numbering cameras within a site, set the Site Number to Zero.
Default = 0
Trunk
When not selected, cameras are mapped onto a site number; any available trunk will be used if the mapped
cameras are remote.
When selected, the specified input trunk is used to set the site number; only the specified trunk will be used.
Default = off
Use Non Default mode
When not selected the camera maps work in all operating modes.
When selected the camera map will only work in the operating mode that has been specified.
Default = off
Operating Mode
Used to specify an operating mode to which the camera map will apply. When the controller is in a different
operating mode to that specified, the camera map will be disabled.
The operating mode will only be taken into account if the “Use Non Default mode” box is checked.
To change the operating mode, see the “Set Mode” event, on the alarm events tab.
Default = 1
Dialup Sites
Each site in the range 1 to 100 can be configured as a dialup site.
This works in combination with a dialup trunk (Input or Output trunk) setting. All sites set to dialup will share
the same dialup trunk(s). As well as dialup sites, this setting is also used more in a more generic sense to
indicate that the site is dynamically routed (e.g. when it is dynamically routed over IP using a ZSI-450).
Default = Off
