ZSC-1000 User Manual.doc
Issue 18
Page 29 of 46
M
E
Y
E
R
T
E
C
H
L
I
M
I
T
E
D
Z
S
C
-1
0
0
0
Site Routing
Defines information that is used to describe the communications interface to a remote site.
For each Site 1 – 100 the following site routing table can be set up
Site Routing
•
Route through PC1 Port
Commands are routed out of the PC1 port
Default = Off
•
Route through PC2 Port
Commands are routed out of the PC2 port
Default = Off
•
Simplex
The remote site is operating in simplex mode, indicates to the local unit that it should not wait for a
reply from this site.
Default = Off
•
Unswitched Trunks
Modifies the behaviour of the input trunks from a site, so that different trunks will be used for different
remote cameras, assuming the remote camera number matches the trunk number
Default = Off
•
Legacy controller (ZVD-GW1)
Modifies the protocol used to communicate with the remote site controller
Default = Off
•
Intersite port IP site
Indicates that the site is on the intersite port but is dynamically routed. This is used in conjunction
with the dial up site tick box.
Default = Off
•
Through Routing (e.g. TVNP)
Indicates that the site is on a network capable of routing video from many sites through shared input
trunks. Currently applies only to the TVNP network.
Default = Off
•
Reserved
Internal use only – MUST NOT BE MODIFIED
Default = Off
