![background image](http://html1.mh-extra.com/html/zoll/road-safety-rs-4000/road-safety-rs-4000_system-overview-and-installation_3991979027.webp)
© 2016 ZOLL Data Systems, Inc. All rights reserved.
20
CONFIDENTIAL TRADE SECRETS – DO NOT DISCLOSE.
Z
O
L
L
D
o
c
u
m
e
n
t
a
t
i
o
n
STEP 6: MOUNT THE RS-3211-1 DRIVER ID RECEPTACLE
The RS-3211-1 Driver ID Receptacle reads driver ID tags that associate a driver to the vehicle for reporting
purposes.
Typical mounting locations – On the dash in close proximity of the ignition switch. Placement should allow the
driver to reach it easily when sitting in the driver's seat.
Drill a hole through the panel at the chosen location using a 13/16” or 20mm drill bit. See Appendix C and Form 3
Build Sheet for wiring assignments.
1.
Feed the wires into the hole and through the mounting nut until the receiver is seated fully into the panel.
2.
Pass the wires through a 15/16” or 24mm deep socket, position socket onto the nut and hand tighten
only.
3.
Connect the wires from the receiver to RS-4105 Expansion harness wires.
On dash near ignition switch
NOTE:
The panel should not be greater than 3/16” (4.76mm) thick and have sufficient room behind it for the
back end of the receiver and wiring to fit without interference.