Zodiac AquaLink PDA P4, Owner'S Manual

Page: 15 / 132

Page 15
ENGLISH
AquaLink
®
PDA | Installation and Operation Manual
Section 4. Using the Equipment On/Off Model Specific Menus
4.1 TEMP1 (Pool or Spa Only)
NOTE
This equipment may not be part of your system. Please check with your installer.
TEMP1 is the priority temperature. It must be set higher than TEMP2 , and it overrides TEMP2 whenever it is
enabled. Set temperature for TEMP1 before setting temperature for TEMP2 .
4.1.1 To set TEMP1 (Pool or Spa Only)
Highlight EQUIPMENT ON/OFF and press SELECT. Highlight TEMP1 and press SELECT twice. Use the UP/
DOWN arrow keys to set the desired water temperature and press SELECT to make that degree setting take effect.
Return to the main menu by using the BACK button.
4.2 TEMP2 (Pool or Spa Only)
NOTE
This equipment may not be part of your system. Please check with your installer.
TEMP2 is the maintenance (low) temperature. It must be set lower than TEMP1 . If TEMP2 is on and TEMP1 is
activated, TEMP2 will turn off and ENABLED will flash. When TEMP1 is turned off again , TEMP2 will reactivate.
4.2.1 To set TEMP2 (Pool or Spa Only)
Highlight EQUIPMENT ON/OFF and press SELECT. Highlight TEMP2 and press SELECT twice. Use the UP/
DOWN arrow keys to set the desired water temperature and press SELECT to make that degree setting take effect.
Return to the main menu by using the BACK button.
TEMP2
ENABLED
SET TO 60°F
Use ARROW KEYS
to set value.
Press SELECT
to continue.
EQUIPMENT
FILTER PUMP
TEMP 1
TEMP 2
SOLAR HEAT
POOL LIGHT
AUX 2
AUX 3
AUX 4
MORE
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
OFF
ON
OFF
OFF
OFF
OFF
OFF
TEMP1
must be set
higher than
TEMP2
press ANY key
to continue.
EQUIPMENT
FILTER PUMP
TEMP 1
TEMP 2
SOLAR HEAT
POOL LIGHT
AUX 2
AUX 3
AUX 4
MORE