Ziton ZP1-F2, Installation Manual

Page: 105 / 113

Appendix A: Configuration presets
ZP1-F Series Installation Manual 99
Table 66: Expansion board event configuration with EN 54-13 supervision enabled
Display Event
Outputs Delay Display Event Outputs Delay
24 Alarm 1 and 2,
3 and 4
No 32 [2] Fire protection 1 and 2 No
Fault warning
output [3]
3
Fault [1], [5] 4
25 Fault 1 and 2
3 and 4
No 33 Buzzer on 1 and 2 No
Reset on 3 and 4
26 Alarm 1 and 2 No 34 [2] Fire routing
(auto)
1 and 2 No
Fault 3 and 4 Fire routing
(manual)
3 and 4
29 Fault [1] 1 and 2
3 and 4
No 35 [2] Fire routing 1 and 2 No
Fault warning
output [3]
3
Fault [5] 4
30 Alarm 1 and 2 No 36 [4] Remote
RB/SBx.01-02
output
activation
1 and 2 No
Fault [1] 3 and 4 Remote
RB/SBx.03-04
output
activation
3 and 4 No
[1] Fail-safe mode: output is active when there is no fault.
[2] These presets are only available for 2010-1-SB supervised expansion boards.
[3] NEN 2535 only. Fault warning output open supervision (subject to input configuration).
[4] RB/SBx is the expansion board x. For two-zone and four-zone panels, x can be 1 or 2. For 8
zone and evacuation panels, x can be 1, 2, 3 or 4.
Configuration 36 is only possible when the Network Remote Output Control option (nO) is set
and it is then configured by default
[5] Not compliant to EN54-13.
Table 67: Expansion board sounder circuit configuration with EN 54-13 supervision
enabled
[1]
Display Events Output Delay
90 [2] Evacuation sounders 1 and 2 No
Warning sounders 3 and 4 No
91 Sounders (or
Evacuation sounders
for NBN S 21-100)
1 and 2 or 3 and 4 No
92 [2] Warning sounders 1 and 2 or 3 and 4 No
[1] These presets are only available for supervised expansion boards.
[2] NBN S 21-100 only