Ziton ZP1-F2, Installation Manual

Page: 55 / 113

Chapter 3: Configuration and commissioning
ZP1-F Series Installation Manual 49
Zone configuration
Use this menu to configure zone settings for each zone in your fire alarm system.
The default setting for each operating mode is included in Appendix A
“Configuration presets” on page 89.
To configure the zone:
1. Set the display as shown below, and then press Enter.
2. Select the zone (for example, zone 1), and then press Enter.
The Zone fault/test/disable LED flashes fast to indicate that the corresponding
zone configuration menu is active.
3. Select a value using the value selection buttons (2 and 4).
4. Press Enter.
5. Save your changes.
The available settings for this feature are shown below.
Display Description
Passive end-of-line
Active end-of-line [1]
Unlatched (only available in BS 5839-1 mode) [1]
Passive end-of-line with CleanMe [1][2][3]
Active end-of-line with CleanMe [1][2][3]
Intrinsically-safe zone [1][4]
[1] Option not available if EN 54-13 supervision is enabled.
[2] Option not available if operating mode is NEN 2535.
[3] The CleanMe feature is not available for Ziton devices.
[4] By default, even zones are configured as manual and odd zones are set
as automatic.