Zeroplus LAP-C(16032), User Manual

Page: 71 / 130

Smart+
User’s Manual V1.04.04
71 FM07I4A
Channel Selection
: Each channel can be set as Don’t care, High Level or Low Level. See below description:
1.
=Don’t Care. This is the default setting, which means all signal will be captured.
2. =High Level. The LA will capture signal that contains High Level. For example: the 4
th
channel is set as High,
then the LA will capture the signal that contains High Level in the 4
th
channel, the other signal will not be captured.
3. =Low Level. The LA will capture signal that contains Low Level. For example: the 2
nd
channel is set as Low,
then the LA will capture the signal that contains Low Level in the 2
nd
channel, the other signal will not be captured.
Select Filter Type
: There are “Filter Condition” and “Inverse Filter Condition” to choose, the default is “Filter
Condition”.
Reserved Area
: There are “During the period when the condition is coincident”, “After the Start Point of the condition,
prolong”, “After the End Point of the condition, prolong” and “ Delay” to choose, the default is “During the
period when the condition is coincident. For the last three options, their time range is 1-65535 clocks. “During the
period when the condition is coincident” is selected by default.
Display Bar Setup : When activated, there are “Original Width” and “User Defined” to choose, the default is not
activated. The defined range is 1 - 65535 clocks).
4.10 Add Channel/Bus Setup
Users can add Channel, Bus or Protocol Decoders, the default is Protocol Decoders.