Zeroplus LAP-C(16032), User Manual

Page: 70 / 130

Smart+
User’s Manual V1.04.04
70 FM07I4A
Reset Find : Find the data that fitting the condition again from the start point.
Previous : Find the previous data that fitting the condition.
Next : Find the next data that fitting the condition.

Note 1: If one condition page is set as trigger condition, it would be marked by a ‘*’.

Note 2: “All Highlight Tips” could only be used for Bus/Protocol Analyzer trigger.

Note 3: Find would be done based on conditions on current page, as is the control panel.

Note 4: If page switched, then find would be done based on conditions on the page after switching with starting at
the current position.

Note 5: Switching between pages would not affect the Start of find range.
4.8 External Trigger (only supported by LAP-D Series)
Trigger Input : There are Rising Edge, Falling Edge and Either Edge to choose.
Trigger Output : The signal will be output if the condition is satisfied. The condition can be When Trigger Condition,
Start or Stop. The signal can be output at Rising Edge, Falling Edge or Status.
4.9 Signal Filter Setup(not supported by LAP-D Series)