Setup Mode
JesterML Operating Manual
73-406-00 Issue 3.0
53 of 85
Leaving the Assign Fixtures menu
Select <Exit> and press ENTER to leave the Assign Fixtures menu. If any fixtures or
RDM devices require patching, then a prompt will be given to enter the DMX Patch
menu to do this.
Pan/Tilt Options
This menu allows you to set up the fixtures so that the Pan & Tilt Wheels on the desk
operate as expected, according to how you have rigged the fixtures. The following
three options are presented for each fixture with Pan & Tilt:
•
Pan Inv
Inverts the pan channel.
•
Tilt Inv
Inverts the tilt channel.
•
P/T Swap
Swaps the pan & tilt channels.
Record Options
By default the desk operates in ‘Partial’ mode. This means that parameters must be
‘tagged’ to be recorded. Parameters are automatically tagged by the desk when they
are changed, or you can manually tagged/untag them. Additional options allow you
to define how the tagging is treated for each attribute. By switching the desk into
‘Full’ mode, everything is recorded and tagging is not used, however this results in
less flexibility particularly for Palettes and Submasters.
To change these options, use the cursor buttons to select <Record Options> and
press ENTER.
The ‘Mode’ setting allows you to choose between the Partial and Full recording
modes described above. Select this field and press ENTER to toggle the recording
mode. When ‘Partial’ is selected, the following 4 options will be presented:
Brightness: All/Channel
When set to ‘All’, fixture intensity channels and preset channels are always
recorded. When set to ‘Channel’, fixture intensity channels and preset channels
must be tagged to be recorded. The default setting is ‘All’. Since all brightness
channels are mixed HTP and thus can be excluded by simply programming at
0%, it should not normally be necessary to change this setting.
Colour: All/Channel
When set to ‘All’, if one colour parameter is changed by moving a wheel, then all
colour parameters for the currently selected fixtures are automatically also tagged
by the desk. When set to ‘Channel’, only the adjusted colour parameter is tagged
by the desk. The default setting for colour is ‘All’.
Beamshape: All/Channel
When set to ‘All’, if one beamshape parameter is changed by moving a wheel,
then all beamshape parameters for the currently selected fixtures are
automatically also tagged by the desk. When set to ‘Channel’, only the adjusted
beamshape parameter is tagged by the desk. The default setting for beamshape
is ‘Channel’.
Summary of Contents for JesterML
Page 1: ...OPERATING MANUAL including...
