JesterML Operating Manual
Setup Mode
48 of 85
73-406-00 Issue 3.0
on the Main LCD, e.g.
Lamp
. With the fixture number highlighted on the Main LCD,
use the left and right cursor buttons to select the other
parts
(e.g.
Scroll
) of the fixture
for patching.
Setting the default patch
To clear the DMX patch back to default, press and hold the clear button for 1 second.
All fixtures will be unpatched. The preset channels will be patched as follows:
JesterML
JesterML24
JesterML48
No DMX Input
Not patched
1-24 1:1
1-48 1:1
DMX Input present
1-48 1:1
1-48 1:1
1-48 1:1
Note that the default patch is not dependant on the
Wing Width
setting.
Auto patch
To automatically patch all fixtures sequentially according to their channel usage, hold
down the SHIFT and CLEAR buttons together for 1 second. The previous patch will
be cleared, and a new patch automatically created. The preset channels will be
patched as shown in the default patch table above, and the fixtures will be begin at
the next available DMX address.
Previewing the patch
While in DMX Patch Mode, the brightness of the selected fixture is set to 100%, so
that the fixture can be identified in the rig and the patch visually confirmed. Other
fixtures are set to 0%. To make it easier to identify fixtures in DMX Patch, you may
wish to first Home all of the fixtures in a normal operating mode before entering
Setup. This will ensure all LTP channels are set to default values.
All of the preset faders are active in DMX patch mode, so that they can be faded up
and down to test the patch easily. If a wing is in use, faders on the wing can be
used.
For the outputs to be seen, the Grand Master must be raised, and the desk must not
have Blackout active.
Summary of Contents for JesterML
Page 1: ...OPERATING MANUAL including...
