Zennio ZVI-TMDP4, User Manual

Page: 48 / 61

Touch-MyDesign Plus
http://www.zennio.com Technical Support: http://zennioenglish.zendesk.com/
48
Figure 34 General – Sounds.
Disable Button Sounds : enables or disables the beeps on the execution of an
action after the user touches a button. If disabled (default option) the following
parameters will also be available:

State of Button Sounds after ETS Download : sets whether the button
beeping function should start up enabled (default option) or disabled after
an ETS download. This makes sense if the “ Enable/Disable Button
Sounds Using 1-Bit Object ” checkbox (see below) is enabled too.

Enable/Disable Button Sounds Using 1-Bit Object : enables or disables
the option to stop / resume the button beeping function in runtime by
writing to a specific object (“ [General] Sounds: Enable ”). The values (0 or
1) that will disable the beeps after the button touches and then re-enable
them are parameterisable through “ Value ”.
Doorbell Object : enables or disables the doorbell function. If enabled, a
specific object (“ [General] Sounds: Doorbell ”) will be included into the project
topology. The value that will trigger the sound (1 or 0) must be set entered in
“ Value ”.
Alarm Object : enables or disables the alarm function. If enabled, a specific
object (“ [General] Sounds: Alarm ”) will be included into the project topology.
The values (1 or 0) that will trigger the alarm sequence and then stop it must be
entered in “ Value ”.