Zennio ZVI-TMDP4, User Manual

Page: 20 / 61

Touch-MyDesign Plus
http://www.zennio.com Technical Support: http://zennioenglish.zendesk.com/
20
Action on Long Press : sets the value that will be sent through “ [X] Two
Objects: Long Press ” after the user long-presses one of the two buttons.

“Left: 0; Right: 1” (or “Down: 0; Up: 1” under a horizontally-oriented
configuration.

“Left: 1; Right: 0” (or “Down: 1; Up: 0” under a horizontally-oriented
configuration.
Note: this parameter will remain hidden unless having selected “Every button
pair is configured separately” in Button Pair Action (see section 2.1).
Long Press Threshold Time : sets the minimum time the user should hold the
button in order to consider it a long press. The available range is 4 to 50 tenths
of a second, being 6 tenths the default value.
LED Illumination Control : analogous to the homonymous parameter for the
Switch and Dimmer functions (see above). In this case, however, selecting
“State-dependent” or “State-dependent (both LEDs)” brings an additional
parameter, “ LED Illumination State Object ”, to make the state of the LEDs
correspond either to object “ [X] Two Objects: Short Press ” (“Short Press
Object”) or to object “ [X] Two Objects: Long Press ” (“Long Press Object”).
Figure 14 Pair Buttons - Two Objects (Short Press / Long Press) - LED Illumination Control.
2.2.1.3 INDIVIDUAL
Buttons of pairs configured to work as individual (separate) controls can be assigned
any of the following control functions:
Disabled : user presses will not trigger any function although the LED will still
react to them, if configured.
Binary : whenever the user touches the button, a binary value will be sent to the
KNX bus. This value is configurable and may be 0 or 1, or alternate with every
touch according to the sequence 1

0

1

…