Touch-MyDesign Plus
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com/
23
Under a “
state-dependent
” LED illumination, the LED will remain on/off
according to the following:
After sending a switch-on order to the bus, the LED will turn on. After
sending a switch-off order to the bus, the LED will turn off.
After sending a dimming order greater than 0%, the LED will turn on. After
sending a dimming order equal to 0%, the LED will turn off.
After receiving from the dimmer the on/off status object, the LED will turn
on/off depending on the value of the object.
After receiving from the dimmer the dimming status object, the LED will
turn on/off depending on whether the value is greater than 0% or not.
Note
: after a bus failure, the LED will remain off unless after the bus recovery
the light dimmer sends back the on/off status object or the dimming status
object updated.
Shutter
: implements a one-button shutter control that sends orders to the KNX
bus, which can then be executed by an actuator.
Two control types can be configured:
Standard: the device will react to both long and short presses, being
possible to send the bus the following commands:
•
Move (raise / lower) orders (on
long presses
).
•
Stop / Step orders (on
short presses
).
The specific raise / lower orders which the button will be able to send may
be chosen from the three following available actions:
•
Up: a short press will always send a step-up / stop order, while a
long press will always send a
move
up
order.
•
Down: a short press will always send a step-down / stop order, while
a long press will always send a
move down
order.
•
Toggle: choosing this option, the direction of the motion will
alternate
(upwards / downwards) for both the move and the step
