Touch-MyDesign Plus
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com/
25
•
If the position of the shutter is found to be 0%, the next order
will lower the shutter.
•
If the position of the shutter is found to be 100%, the next
order will raise the shutter.
Touch-MyDesign Plus is aware of the current
position of the shutter
through a specific object which should be linked to the analogous object of
the shutter actuator, in order to receive feedback. This object is initialised
with value “50%” after a download or a bus failure; therefore, the actuator
is required to update it with the real value after the bus recovery.
The “
state-dependent
” LED illumination mode is not available for this
function.
ETS PARAMETERISATION
When an individual button has been enabled, a specific tab (“
Button X1
” or “
Button
X2
”) becomes available under “Main Buttons” in the tree on the left.
Figure 15
Individual Button.
Note
:
the INFO textboxes are functionless (they simply bring the option to add a
description to each button of the project) and can be hidden if desired. See section 2.1
.
The main parameter that needs to be configured is:
Function
: sets the desired function for the button: “Disabled”, Binary”, “Hold &
Release”, “Two Objects (Short Press / Long Press)” or “Scene”, “Scaling
Constant”, “Counter Constant”, “Float Constant”, “Dimmer” and “Shutter”.
Depending on the function, some more parameters are involved (as described next).
Please note that in the next pages “
[Xn]
” is used as a general notation for the
