Square TMD-Display
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com
32
ETS PARAMETERISATION
This function has no related parameters.
2.3.3
PAIR
Buttons configured to work as a joint control can be assigned the following functions:
Switch
: pressing one of the two buttons will make Square TMD-Display send
a binary value to the bus, while pressing on the other will make it send the
inverse binary value. It is possible to configure which one does what.
Under a “
state-dependent
” LED illumination (see ANNEX I: LED Illumination
Modes), the LED of the corresponding button will remain on/off according to
the current state (on/off) of the switch. On the other hand, under a “
state-
dependent (both LEDs)
” LED illumination, both of them will remain on while
the switch is in the “on” state, and off while in the “off” state.
Two Objects (Short Press / Long Press)
: permits sending specific binary
values both after a short or a long press on any of the two buttons (i.e., they
will work as a joint control; for independent buttons, please configure them as
individual). Different objects will be used for the short and long presses.
Moreover, it is possible (in parameters) to make the “
state-dependent
” and
“
state-dependent (both LEDs)
” LED illumination modes (see ANNEX I: LED
Illumination Modes) depend on either one object or the other. However, if
“
LED Illumination Control (All Buttons)
” (section 2.3.1) has been set to
“state-dependent (where available)” only the short press object will be
considered
Dimmer
: short-pressing one of the two buttons will make Square TMD-
Display send a switch-on order to the bus, while doing so on the other button
will make it send a switch-off order.
Long presses will make it send a step dimming order (the value of which is
configurable) to make a dimmer increase or decrease the light level (and a
stop order as soon as the user releases the push button). It is possible to
configure which button does what.