Zennio ZVI-SQTMDD, User Manual

Page: 19 / 102

Square TMD-Display
http://www.zennio.com Technical Support: http://zennioenglish.zendesk.com
19
The values (0 or 1) that will disable / resume it are parameterisable
through “ Value ”.

Button sound after ETS Download : sets whether the button beeping
function should start up enabled (default option) or disabled after an ETS
download. This makes sense if the “ Enable/Disable Button Sounds
Using 1-Bit Object ” checkbox (see below) is enabled too.
Object for doorbell : enables or disables the doorbell function. If enabled, a
specific object (“ [General] Sounds: Doorbell ”) will be included into the
project topology. The value that will trigger the sound (1 or 0) must be set in
“ Value ”.
Object for alarm bell : enables or disables the alarm function. If enabled, a
specific object (“ [General] Sounds: Alarm ”) will be included into the project
topology. The values (1 or 0) that will trigger the alarm sequence and then
stop it must be entered in “ Value ”.
2.2.6 ADVANCED
As stated in section 2.2.1, an independent tab for the parameterisation of some
advanced functions is shown in ETS if enabled from the “Configuration” tab.
These functions are explained next.
ETS PARAMETERISATION
The “Advanced” tab (Figure 11) contains the following parameters:
Figure 11 General - Advanced.