ZENN
iO
AVANCE Y TECNOLOGÍA
vwww.zennio.com
7
Status objects.
Reports on the actual position of the shutter.
Precise control.
Allows moving the shutter to any position (in percentage: 0-100%,
defined by parameter) on its length. Moreover, for blinds with slats, it is also possible to
establish a desired position for the slats (value between 0% and 100%).
Scenes.
Allows running and/or saving a specific action over the channel/s where this
function is enabled.
Alarms.
Two alarms available for each shutter channel. They execute the action defined
by parameter when receiving a specific external event.
Reversed moving.
It makes possible to control shutters the other way around from usual.
Direct positioning.
Function to move a shutter to a prefixed specific position via 1 bit
communication object.
Start-up configuration.
Default or custom.
All these configuration options are explained in detail in the section 3. ETS Parameterization.
2.3. RELAY CONTROL USING IR REMOTE
ACTinBOX MAX6 actuator incorporates in its design an infrared receiver, located next to the
programming LED. This functionality allows testing the actuator outputs, during the installation, from
the Zennio infrared remote control (the same used to control the touch panel InZennio Z38i. See
Figure 2.1).
Note: To control the outputs from the IR remote, it is necessary to have the programming LED lit
(lighting red).
The outputs control is carried out as follows:
Push the
right button
: close the corresponding output relay
Push the
left button
: open the corresponding output relay
In the Figure 2.1 it is shown a representation of the buttons of the IR remote that must be pressed,
depending on the output to be remote controlled.
