Zeiss S88, Instructions For Use Manual

Page: 112 / 182

112
Operation
G-30-1426-en S88 Floor Stand with Lifting Column Issue 9.0
Printed on 28. 01. 2009
scope, as the image you see displays constant brightness throughout the
zoom range. Only when looking directly at the surgical field will you notice
that the brightness of the illumination varies, depending on the zoom set-
ting.
Note:
If you have selected a relatively high basic brightness in the basic mode,
the automatic function may not be able to sufficiently compensate for re-
duced transmission of the optical system.
Defining the power-on behavior of the system (OPMI Vario)
The "POW ON MODE" function permits you to define how the system
should behave immediately after it has been switched on.
You have the choice between the following power-on modes:
Roll-over procedure:
Display Function
OFF No positions are changed when you switch on the system.
After power-on, you can use the appropriate buttons of the
foot control panel or handgrips to
manually set the focus
and zoom to the user-defined values saved in the memory
function.
PRESET On power-on, the focus (working distance) and zoom are au-
tomatically set to the default factory settings: focus = 250
mm and zoom = 0.5.
These two values are also saved in the memory function
(FOC-MEM and ZOOM-MEM).
MEM After power-on, the focus (working distance) and zoom are
automatically set to the user-defined focus and zoom values
saved in the memory function. The values in the memory
functions FOC-MEM and ZOOM-MEM can be saved for spe-
cific users by pressing the STORE button.
→
MEM
→
OFF
→
↑ ↓
←
PRESET
←
Path: To return to the basic mode, press the MODE button in the config-
uration mode, or do not press any button for 20 seconds.
To change to configuration mode 3 (SETTINGS 3), press the
MODE and STORE buttons simultaneously.
MODE
STORE MANUAL
SPEED
FUNCT:
MEDIUM
LIGHT
FUNCT:
MANUAL
POW ON
MODE:
MEM
Configuration
mode 2
SETTINGS 2