Zeiss Humphrey Matrix 800, User Manual

Page: 110 / 158

Printer Configuration
Humphrey Matrix User Manual 2660021138935 Rev. F 2015-11
9-2
Printer Safety
WARNING: To maintain patient safety, an isolation transformer is required
when connecting externally powered peripheral devices (i.e., printer, USB
drive, etc.) within 1.5 meters (4.9 feet) from the patient. In addition, a
seperation device is required for all externally powered peripheral devices
outside this distance unless these devices have no metal to metal
connection to the Martix via I/O connectors. Failure to observe this
warning could result in electrical shock to the patient and/or examiner.
WARNING: To directly connect a network printer to the Matrix only use a
UTP network cable. Use of a shielded network cable will ground the
printer through the Matrix, which could result in electrical shock to the
patient and/or examiner. It could also invalidate the system safety
approval.
CAUTION: Do not use the printer or the instrument with an extension cord or a
power strip (multiple portable socket outlet).
Installation Overview
The following three general steps are common to all configurations. These steps are
explained further in the specific sections.
1. Printer hardware setup and configuration: Refer to the instructions provided with the
printer to unpack and set up the printer hardware. Printer configuration is typically not
required.
2. Connect hardware to enable communication between instrument and printer. The
hardware used depends on the type of configuration you select either a printer on a
network or a local printer.
3. Configure the instrument software to communicate with the printer. See Print
Settings on page 9-5 to connect the Matrix to a local, shared, or network printer.