START-UP
ZEISS
Mounting optional components
Axioscope 5/7/Vario
78
430035-7344-001
03/2018
3.2.8
Inserting the modulator disk in the
0.9/1.25 BF condenser
•
Remove the condenser (
1
) from the
condenser carrier (see section
If the condenser cannot be lowered sufficiently,
e.g. with mounted low-power system, then it
might become necessary to remove it with the
stage carrier, then lower it to the stop and
remove the condenser.
•
Loosen the clamping screw (
5
) of the
condenser’s dial segment (
3
) with the
Allen wrench (AF 3) and pull out the dial
segment.
•
Slide the modulator disk (
4
) with its
two-pronged forked opening pointing forward
into the condenser. Make sure that the disk
engages in the guide on both inner sides of the
condenser. The guide serves as a stop for the
modulator disk. The pin of the disk’s clamping
screw must slide into the orientation groove of
the condenser.
•
Tighten the disk’s clamping screw with the
Allen wrench (AF 3).
•
Replace the condenser into its carrier (see
section
Fig. 3-48
Inserting the modulator disk in the
0.9/1.25 H condenser