Zeiss Axio Zoom.V16, Operating Manual

Page: 42 / 66

OPERATION
Carl Zeiss Switching on Axio Zoom.V16
42 435080-9030-701 05/2012
4.2.6 Saving a focus position
The current focus position will be stored when key
3
(Fig. 27/
3
) is pressed for between 2 and 5 seconds.
The green LED (Fig. 27/ 6 ) will briefly light up and one short beep tone on the motorized focusing system
issued to indicate completion of the storing process after 2 seconds.
4.2.7 Traveling to the saved focus position
When key
3
(Fig. 27/
3
) is pressed for < 2 seconds the motor will travel to the stored focus position.
4.2.8 Reversing rotation of MaRC
The direction of rotation will be reversed if key 3 (Fig. 27/ 3 ) is pressed for more than 5 seconds.
While pressing, first of all a
single
beep tone, then
two
tones will be issued and the green control lamp
(Fig. 27/ 6 ) will flash once or twice. This indicates that the reversal has been completed.
Reversal of the direction of rotation means that the MaRC control unit can be mounted and operated
either to the right (for right-handed persons) or to the left of the microscope (left-handed persons)
4.3 Switching on
The instrument has been properly set up and connected (see Sections 3.2 to 3.12, from page 18).
•
Unlock the STOP button to the right or left of the focusing drive by pulling it out.
•
Briefly press the button on the HIP.
•
Switch on the illumination (see separate operating manual).
4.4 Switching off
•
Briefly press the button on the HIP.
•
Pull the plug-in power supply from the mains socket.
•
Switch off the illumination (see separate operating manual).
The instrument has now been switched off.
See the appropriate operating manual for switching off other instruments.