OPERATION
Axio Zoom.V16
Human interface panel control unit (HIP)
Carl Zeiss
05/2012
435080-9030-701
39
•
Press the
Mode
button briefly several times to select the desired parameter
•
To change a parameter value, move the knurled wheel up or down (
) until the desired value is
displayed, e.g.
Set Lens 0.5x
1.0x
2.3x
•
To select other parameters, press the
Mode
button again.
Once all parameters have been set, you may change to the
Basic
mode.
•
To do this, press the
Mode
button for two seconds until an acknowledgement signal (1x long) is
heard and the display switches over. All modified values are now saved.
The new values will not be permanently saved until you switch to Basic mode. Switching off
with the button or cutting the power supply in
Setting
mode will result in a loss of the
modified values.
General parameters
Values
Remarks
Backlight
Adjustment of display backlight 12-stage progress bar
Increasing background brightness
Reducing background brightness
Beep Level
Switch acknowledgement
signal on/off
ON
→
OFF
Activation recommended
Zoom parameters (only zoom control)
Values
Remarks
Set Lens
Changing objective
enlargement
PlanApo Z 0.5x
PlanApo Z 1.0x
PlanNeoFluar Z 1.0x
PlanNeoFluar Z 2.3x
Apo Z 1.5x
required for correct display of
magnification
Set Eyepiece
Change eyepiece magnification 25x/10foc
16x/16Br foc
10x/23Br foc
10x/20Br foc
required for correct display of
magnification
Confirmation
Activating/deactivating the
start query
ON
→
OFF
Start query is useful only if the
magnification level of
objectives/eyepieces is to be changed
frequently
Zoom speed
Setting the speed
1
→
2
→
3
flat
→
steep speed profile
Reset Param?
Reset to factory default
NO
→
YES
Focus parameters (only focusing control)
Values
Remarks
Focus Speed
Setting the speed
1
→
2
→
3
slow
→
fast
only relevant for focus speed, not fine
focus
Reset Param?
Reset to factory default
NO
→
YES
Summary of Contents for Axio Zoom.V16
Page 1: ...Operating Manual Axio Zoom V16 Zoom microscope...
Page 2: ......