Zeiss Axio Zoom.V16, Operating Manual

Page: 36 / 66

SET-UP
Carl Zeiss Making electrical connections Axio Zoom.V16
36 435080-9030-701 05/2012
3.12 Making electrical connections
Do not switch the microscope on until all cables have been connected.
Fig. 25 Connecting the microscope
•
Join the CAN bus connections of the CAN components used in any sequence to the
CAN A
to
CAN D
ports of the focusing drive.
In the absence of the motorized focusing drive (focus motor) each electronic CAN component
can be operated with a separate PSU. In this case, the body of the Axio Zoom.V16 microscope
must be connected directly to the mains via the plug-in power supply.
If two or more CAN components are connected to each other, only one power supply unit may
be used.
Item No.
(
Fig. 25
)
Name/Order No. Figure Remarks
 CAN cable RJ 45
Included with each
CAN component
Connection between focus
motor 3 and body of the
Axio Zoom.V16 microscope
and between focus motor 3
and MaRC
L=500 mm or
L=1000 mm
 Plug-in power
supply
Power supply to focus motor
3 or body of the Axio
Zoom.V16 microscope with
coarse/fine drive