y t
0 9
BASE
RACEFACE AEFFECT
HANDLEBAR ASSEMBLY
Remove the handlebar clamp on the stem by
removing all screws (Allen key 4 mm ).
Install the handlebar. Mount the handlebar to
the stem (Allen wrench 4 mm).
Start with the uppermost bolts, torqueing
down the top part of the stem clamps ac-
cording to the manufacturer’s specifications.
Take care not to leave a gap here (zero gap).
Only then should you secure the handlebar
with the lower bolts as well.
Raceface Aeffect:
Steerer tube screws //
8 Nm
Handlebar clamp screws
at the top //
4 Nm
underneath //
6 Nm
Make sure that the clamp gaps under the low-
er stem bolts are even, and that the handlebar
is correctly centered and aligned in the stem
– there are markings to assist you with this.
Torque all bolts precisely to the spec indicated
by the stem and/or handlebar manufacturer.
2.3.1
2.3.2
2.3.3
2.3.4
Please follow the
torque specifications of
the manufacturers:
EN
