y t
1 1
3.2.1
3.2.4
3.2.2
3.2.5
3.2.3
EN
Make sure that the bike is properly positioned
on the rear axle stand.
Carefully remove the cable tie with a wire cut-
ter. Then remove the bubble wrap as well as
the protective foam from the rear derailleur.
Screw the derailleur bolt in, but do not tighten
it yet in order to be able to align the derailleur
properly in the next step (5 mm Allen key).
REAR DERAILLEUR ASSEMBLY
SHIMANO DEORE XT DI2
Rear derailleur screw //
8 – 10 Nm
Use the torque wrench to tighten the derail-
leur bolt. Make sure that the derailleur tab sits
against the corresponding tab on the derail-
leur hanger. Hold the derailleur in place with
your second hand to avoid it rotating out of
position and leaving a gap between the tabs.
Connect the Di2 cable to the derailleur.
Please follow the
torque specifications of
the manufacturers:
