YOKOGAWA F3CU04-0S, User Manual

Page: 47 / 260

A4-13
IM 34M06H62-02E 2nd Edition : June 2008-00
2
4
6
8
1
3
5
7
10
12
14
16
18
9
11
13
15
17
OUT1
GND
24V
OUT2
OUT3
OUT4
OUT6
OUT7
OUT8
OUT5
OUT2-
OUT3-
OUT4-
OUT5-
OUT6-
OUT1-
OUT8-
OUT7-
2 4 6 8
1 3 5 7
10 12 14 16
18 (shared)
9 11 13 15
17 (shared)
OUT1 OUT2 OUT3 OUT4 OUT6 OUT7 OUT8 OUT5
GND
24 V
O.C.
GND
24 V
NC
Load
Load
b) Output Terminal Wiring Diagram for F3CU04-1S
a) Output Terminal Assignment for F3CU04-1S
(Analog Output) (Open Collector Output)
Note: The output type may be selected for each loop of F3CU04-1S. For details on output type selection, see Section B3.1.4,
"Setting Output Terminals." Wiring depends on and thus must be done according to the output type selected.
Figure A4.11 Output Terminal Wiring Diagram for F3CU04-1S
If F3CU04-1S is used for current output to drive an external load with the OUTPUT
parameter set to "Analog," ensure that the wires from the 24 V power supply are
connected correctly as shown in the above figure before supplying the power to the
module. The module will be damaged if the positive wire of the 24 V power supply is
wrongly connected to a negative load terminal (terminal number 2, 4, 6, 8, 10, 12, 14, or
16).
If the output terminals of F3CU04-1S are configured as open collector output, share the
24 V DC power supply of the module as shown in the above figure. No wire must be
connected to the terminals of F3CU04-1S marked "NC" in the output terminal wiring
diagram for open collector output if the Output Type Selection (OUTPUT) parameter is set
to “Open Collector”.