9-4
IM 701510-01E
Setting up the determination conditions
23.
Press the “
Setup
” soft key of the GO/NO-GO top menu. The condition setup menu will
appear.
24.
After having selected the “
Mode
” setting of the trace to be measured using the rotary
knob, press the
SELECT key
to select “
ON
”. Pressing the key once again results in
selecting “
OFF
”, and no waveform determination will occur.
25.
After having selected the “
Condition
” setting of the same trace using the rotary knob,
press the
SELECT key
to select the desired condition. When the condition is met,
“NO-GO” will result.
“OUT”
: The waveform under measurement protrudes from the determination zone;
“IN”
: The waveform under measurement enters the determination zone.
26.
Repeat steps 24 and 25 for other traces if necessary.
Selecting AND or OR determination : Logic
27.
After having selected the “
Logic
” setting on the condition setup menu, press the
SELECT key
to select the desired condition. When the condition is met, “NO-GO” will
result.
“AND” : All determinations are “NO-GO”
“IN”
: Any of the determination is “NO-GO”
Sequence determination
28.
After having selected the “
Sequence
” setting on the condition setup menu, press the
SELECT key
to select the desired sequence. The following types can be selected.
“SINGLE”
: Stops determination when a “NO-GO” determination is made
“CONTINUE” : Carries out determination repeatedly until the “
ABORT
” soft key is
pressed
Setting action after determination
29.
After having selected the “
Action
” setting on the condition setup menu, press the
SELECT key
to select the desired action. After a “NO-GO” determination, the data can
be recorded in the following manners.
“NONE”
: No action;
“PRINT”
: A hardcopy of the screen will be printed out on the built-in printer;
“FD(P-P)”
: All waveforms displayed on the screen will be saved to the floppy disk
as P-P compressed data;
“FD(ACQ)” : Acquisition data of all waveforms displayed on the screen will be saved
to the floppy disk as binary data.
30.
After having selected either “
FD(P-P)
” or “
FD(ACQ)
”, move to the
“
FileName
”setting and press the
SELECT key
. The keyboard will be displayed. After
having selected either “
NONE
” or “
”, continue with step 32.
31.
Use the keyboard to enter the name of the file. The entered filename will be displayed at
the “
FileName
”setting. For details how to operate the keyboard, refer to page 4-8.
Returning to the top menu
32.
Return to the GO/NO-GO top menu by pressing the
ESC key
.
9.1 Judging using a Waveform Zone
