Installing and Connecting the OSICS Multifunction Platform
OSICS User Manual
25
2.3.2
Removing an OSICS Module From the OSICS Mainframe
Subject
This section explains how to remove an OSICS module from the OSICS Mainframe.
Before Starting
Make sure you have a medium-small size flat blade screwdriver.
Procedure
1.
2.
On the OSICS Mainframe front panel, loosen the captive screw of the module you
want to remove using a medium-small flat blade screwdriver.
3.
Put your index and middle finger inside the groove located behind the captive screw
notch of the module, and pull the module out as illustrated in the following figure:
Figure 6: Module Installation – Module Removal
4.
Hold the module with both hands by its top and bottom edges and put it in its
original container.
5.
On the OSICS Mainframe front panel, put a cover plate on the empty slot and tighten
the captive screw to secure it in place.
Do not perform any hardware installation or maintenance operation
while the system is in operation.
Do not extract the module by pulling on any of the front-panel
protruding elements, such as the laser protection cap or connectors
because this may loosen or damage those elements permanently.
Do not operate the OSICS Mainframe if a channel-slot is left open.
Always put back the protection cover plate on an empty slot.
CAUTION
CAUTION
CAUTION
