OSICS User Manual
13
Safety Information
Safety Labels and
Symbols on the
Product
Laser Safety
The OSICS multifunction platform is identified as a Class 1 M product and is equipped
with a remote Interlock connector on which a remote on/off switch can be connected (see
Installing the Remote Interlock, p. 27
).
•
The OSICS T100, ECL, DFB, SLD, TLS-AG and TLS-50 modules are classified as
Class 1M products (power values are given in sub-section
Technical Specifications
in
the appropriate module section of the
OSICS User Manual
).
Your safety may be compromised if you do not use the OSICS
multifunction platform in accordance with the instructions given in this
manual and on the labels located on the product.
WARNING
Safety Label
Description
Class 1M Laser Product
The product may have a built-in light source
(depending on the OSICS modules installed), which
makes it a class 1M laser product, as defined by the
standard on safety of laser products (see section
Certification and Compliance, p. 247). This means that
it is safe under all conditions of normal use except
when viewed with optical instruments such as
microscopes and telescopes. Class 1M lasers produce
large-diameter beams, or beams that are divergent.
Laser Radiation Label
This label indicates the location of the laser output.
Do not look directly into the fiber end of an optical
cable connected to any optical output while the
device is in use. This may cause permanent eye
Caution while Handling Label
(OSICS ECL and T100 modules only). This label is
affixed on the module side panel, as pressing the
sides could result in potential damage to the product.
Electrical Safety Label
This label indicates an injury hazard. It appears on a
location that requires special instructions for proper
use: you must consult the documentation before
using the element of the product where this symbol is
marked (see section Connecting the OSICS Mainframe
Class 1M Laser Product
Invisible Laser Radiation
Do not view directly with
optical instruments
IEC 60825-1:2007
Complies with FDA
performance standards for
laser products except for
deviations pursuant to Laser
Notice N°50 (June 24, 2007)
CAUTION
DO NOT PRESS
FRAGILE OPTICAL
PARTS INSIDE
FUSE 4.0A, 250V, SLOW(T)
TO AVOID ELECTRIC SHOCK, THE
PROTECTIVE GROUNDING CONDUCTOR
MUST BE CONNECTED TO GROUND
100-240V ±10% CATII ~50-60Hz POWER MAX 220W
!
