Using the OSICS SWT APC Module
OSICS User Manual
167
12.10 Configuring the Modulation for All Connected T100 and
ECL Modules (Full-Band Mode)
Subject
The modulation is a typical function of OSICS T100 and ECL modules. For more details on
the modulation of these modules, see section
Using the OSICS T100 Module, p. 173
and
Using the OSICS ECL Module, p. 99
From the OSICS SWT APC, you can configure the modulation for all connected T100 and
ECL modules:
•
To define the modulation source for all connected T100 and ECL modules, see section
Defining the Modulation Source for All Connected T100 and ECL Modules, p. 167
.
•
To control the modulation of all connected T100 and ECL modules, see section
Controlling the Modulation of All Connected T100 and ECL Modules, p. 168
.
Before Starting
•
Set the SWT APC to
Full-Band
) and specify the connected modules (section
Configuring the Full-Band Mode,
12.10.1 Defining the Modulation Source for All Connected T100 and ECL
Modules
Subject
The following section explains how to configure the wanted modulation source for all
T100 and ECL modules connected to the OSICS SWT APC.
The SWT APC has no internal modulation source, so if you set the modulation source to
INTERNAL, the internal modulation source of the corresponding T100 or ECL module will
be used for modulation.
Procedure
1.
Access the SWT APC
Unit Setup
menu (see section
Accessing an OSICS Module Setup
).
2.
Expand the
Modulation
menu and enter the
Source
sub-menu.
The
Modulation Source
sub-menu appears and displays the current selected
modulation source.
Figure 123: SWT APC Unit Setup – Modulation Source
3.
Turn the rotary knob to put the cursor before the wanted modulation source and
press it to validate your selection.
Main
EXIT
1
2
3
4
5
6
7
8
Unit Setup - Modulation source
ESCAPE
▲
Modulation source :
INTERNAL
MAINFRAME
Select a new value.
