Yenista Optics OSICS, User Manual

Page: 20 / 252

Product Presentation
20 OSICS User Manual
Manufacturer Identification
Contact information of the manufacturer.
Class 1M Laser Product
The product may have a built-in light source (depending
on the OSICS modules installed), which makes it a
class 1M laser product, as defined by the standard on
safety of laser products (see section Certification and
Compliance, p. 247 ). This means that it is safe under all
conditions of normal use except when viewed with
optical instruments such as microscopes and telescopes.
Class 1M lasers produce large-diameter beams, or
beams that are divergent.
Laser Radiation Label
Affixed on OSICS modules, this label indicates the
location of the laser source.
Do not look directly into the fiber end of an optical
cable connected to any optical output while the device
is in use. This may cause permanent eye damage.
Caution while Handling Label
(OSICS ECL and T100 modules only). This label is affixed
on the module side panel, as pressing the sides could
result in potential damage to the product.
Electrical Safety Label
This label indicates an injury hazard. It appears on a
location that requires special instructions for proper use:
you must consult the documentation before using the
element of the product where this symbol is marked
(see section Connecting the OSICS Mainframe to a Power
Source, p. 22 ).
WEEE symbol for recycling
See section Certification and Compliance, p. 247 .
EFUP Label (RoHS China)
The product has an environment friendly use period of
40 years. See section Certification and Compliance,
p. 247 .
Warranty Seal
The product cover must not be open, otherwise the
warranty is not valid anymore.
Label Description
Manufactured by:
4, rue Louis de Broglie www.yenista.com
22300 LANNION Tel : +33 2 96 48 37 15
France Fax : +33 2 96 48 73 04
Class 1M Laser Product
Invisible Laser Radiation
Do not view directly with
optical instruments
IEC 60825-1:2007
Complies with FDA
performance standards for
laser products except for
deviations pursuant to Laser
Notice N°50 (June 24, 2007)
CAUTION
DO NOT PRESS
FRAGILE OPTICAL
PARTS INSIDE
FUSE 4.0A, 250V, SLOW(T)
TO AVOID ELECTRIC SHOCK, THE
PROTECTIVE GROUNDING CONDUCTOR
MUST BE CONNECTED TO GROUND
100-240V ±10% C ATII ~50-60Hz POWER MAX 220W
!
Warranty void
if seal broken.