YASKAWA Z1000 CIMR-ZU*A Series, User Manual

Page: 366 / 400

D.2 European Standards
Figure D.1 CE Mark
The CE mark indicates compliance with European safety and environmental regulations. It is required for engaging in business
and commerce in Europe.
European standards include the Machinery Directive for machine manufacturers, the Low Voltage Directive for electronics
manufacturers, and the EMC guidelines for controlling noise.
This drive displays the CE mark based on the EMC guidelines and the Low Voltage Directive.
•
Low Voltage Directive: 2006/95/EC
• EMC Guidelines: 2004/108/EC
Devices used in combination with this drive must also be CE certified and display the CE mark. When using drives displaying
the CE mark in combination with other devices, it is ultimately the responsibility of the user to ensure compliance with CE
standards. After setting up the device, verify that conditions meet European standards.
u
CE Low Voltage Directive Compliance
This drive has been tested according to European standard IEC/EN 61800-5-1:2007, and it fully complies with the Low Voltage
Directive.
To comply with the Low Voltage Directive, be sure to meet the following conditions when combining this drive with other
devices:
n
Area of Use
Do not use drives in areas with pollution higher than degree 2 and overvoltage category 3 in accordance with IEC/EN 664.
n Installing Fuses on the Input Side
Always install input fuses. Select fuses according to the table below.
WARNING! Fire Hazard. Install adequate branch circuit protection according to applicable local codes and this manual. Failure to comply
could result in fire and damage to the drive or injury to personnel. The device is suitable for use on a circuit capable of delivering not more
than 100,000 RMS symmetrical amperes, 240 Vac (200 V class) and 480 Vac (400 V class), when protected by branch circuit protection
devices specified in this manual.
Branch circuit protection shall be provided by any of the following: Non-time delay Class J, T, or CC fuses sized at 300% of the drive input
rating, or Time delay Class J, T, or CC fuses sized at 175% of the drive input rating, or MCCB sized at 200% maximum of the drive input
rating.
Table D.1 Recommended Input Fuse Selection
Model
Manufacturer: Bussmann
Model Fuse Ampere Rating (A)
Three-Phase 200 V Class
2A0011 FWH-40B 40
2A0017 FWH-50B 50
2A0024 FWH-80B 80
2A0031 FWH-100B 100
2A0046 FWH-150B 150
2A0059 FWH-175B 175
2A0075 FWH-225A 225
2A0088 FWH-225A 225
2A0114 FWH-250A 250
2A0143 FWH-275A 275
2A0169 FWH-350A 350
2A0211 FWH-400A 400
2A0273 FWH-450A 450
D.2 European Standards
366 YASKAWA ELECTRIC TOEP C710616 45F YASKAWA AC Drive – Z1000 User Manual