2.2 Mechanical Installation
26
YASKAWA ELECTRIC
TOEP C710656 10B YASKAWA Power Regenerative Unit - R1000 Instruction Manual
■
Vertical Suspension of Models 2A0073, 2A0105, and 4A0105 to 4A0300
When vertical suspension of the regenerative unit is required in an enclosure panel, the orientation of the eye bolts for
these regenerative unit models can be easily changed by turning the eye bolts counterclockwise 90 degrees.
Figure 2.6
Figure 2.6 Adjusting Angle of Eye Bolts
1.
Gradually take up the slack in the wires and hoist the regenerative unit after the wires are stretched tight.
2.
Lower the regenerative unit when ready to install in the enclosure panel. Stop lowering the regenerative unit
when it is near the floor then begin lowering the regenerative unit again very slowly until the regenerative unit is
placed correctly.
◆
Digital Operator Remote Usage
■
Remote Operation
The digital operator mounted on the regenerative unit can be removed and connected to the regenerative unit using an
extension cable up to 3 m long to facilitate operation when the regenerative unit is installed in a location where it can not
be easily accessed.
The digital operator can also be permanently mounted in remote locations such as panel doors using an extension cable
and an installation support set (depending on the installation type).
S / N : J007XE273710001
Operator
Communication Cable Connector
Communication
Cable Connector
Regenerative Unit
D1000
TOEP_C710656_10B_1_0.book 26 ページ ２０１５年１月８日 木曜日 午後８時５５分
