model no.
060-0608-2
| contact us: 1.866.523.5218
54
MAINT
eNANC
e
RePlACe Self-DRIVe CONTROl CAble
Make sure all fluid are removed and spark plug is disconnected.
Tools required:
–
10 mm wrench.
–
13 mm wrench.
To remove and replace your snowblower’s self-drive cable, proceed as follows:
1. Carefully pivot the snowblower up and
forward so that it rests on the auger
housing. Place a piece of cardboard
or moving blanket on the ground
before tipping forward. Make sure all
fluids are removed and spark plug is
disconnected.
2. Remove the base frame cover (A) from
the underside of the snowblower by
removing the six M6 × 12 bolts.
(Fig. 50)
A
Figure 50
3. Locate the cable (B), slide back any
rubber boot and loosen the top nuts
(C) on each end of the cable as shown.
(Fig. 51)
C
C
b
Figure 51
