model no.
060-0608-2
| contact us: 1.866.523.5218
48
MAINT
eNANC
e
2. Below the panel, loosen the nut (C)
counterclockwise. (Fig. 40)
C
Figure 40
1. Locate the speed control rod (A)
connected to the connecting lever base
(B). Disassemble the speed control rod
from the connecting lever base.
(Fig. 39)
A
b
G
f
e
Figure 39
If the snowblower fails to drive with the drive control engaged and performing the drive
control cable adjustment fails to correct the problem, the friction disc may need to be
replaced. See ‘Repair or Replace Friction Disc’.
If the friction disc is ok, then you should replace the cable.
If you find the wheel drives when the handle is not pressed, or when you press the handle
and the wheels do not drive or rotate, the cable is most likely frozen. You should replace
the cable or wait until it thaws out to test.
ADJUST SPeeD CONTROl leVeR
Make sure all fluids are removed and spark plug is disconnected.
Tools required:
–
13 mm wrench
To adjust your snowblower’s speed control, proceed as follows:
