model no.
060-0608-2
| contact us: 1.866.523.5218
34
OP
eRA
TION
6. Remove snow one auger width beyond street edge by 20-33 feet (6-10 meters) to
the snowplow approach side of your driveway entrance. This will give an area for the
snowplow exit flow to spill off, which will keep the entrance to your driveway free of a
snowplow ridge.
7. Remove snow from around your mailbox to prevent the snow exiting the snowplow from
pushing your mailbox over.
8. Be considerate. Watch your throwing distance and direction to avoid blowing snow on
your neighbor’s house or driveway, and the street.
OPeRATING SPeeD
When throwing snow, it is important that the auger and impeller are kept at a maximum
speed for the best results. This is accomplished by having the throttle control set at fast
(Rabbit position). Ground speed is controlled by selecting 1, 2, 3, 4, 5 or 6 with the self-drive
speed control lever.
Operate in position 1 or 2 (low speed) for heavy snow removal.
Operate in position 3 or 4 (medium speed) for moderate snow removal.
Operate in position 5 or 6 (high speed) for light snow removal and transport.
Snow Removed To Either Side
Snow Removed To Either Side
Start
Here
Finish
Here
Figure 18
A definite pattern of operation is required to thoroughly clean the snow area. This pattern
will avoid a second removal of snow and will avoid throwing snow in unwanted places.
Where it is possible to throw snow to the right and left, as on a long driveway, it is
advantageous to start in the middle. Plow from one end to the opposite end throwing snow
to both sides without changing direction of the discharge chute (Fig.18).
