Torqueing the Rear Engine Mount Bolts
Note: Refer to the Engine Installation
Manual and / or Operation Manual for front
engine mount information.
Torque the rear engine mount bolts.
(1)
(3)
(2)
0006001
Figure 7
1 – Rear Engine Mount
2 – Transom Plate Mount
3 – Bolts
Engine Rear Mount Bolt Torque
N·m
lb-ft
45
33
Checking the Remote Control for
Loose, Missing or Damaged Parts
See Remote Controls on page 17.
Lubricating the Shift Cable and the
Linkages
CAUTION! NEVER grease the steering
cable while extended. Hydraulic lock
could occur and cause loss of steering
control.
Grease the steering cable grease fitting.
1. Turn the steering wheel until the
steering cable is fully retracted into the
cable housing. Apply approximately
three pumps of grease from a typical
hand-operated grease gun.
Note: If the steering cable does not have a
grease fitting, the inner wire of the cable
cannot be greased.
Description
Where Used
Lithium Grease With
PTFE
Steering Cable
2. Turn the steering wheel until the
steering cable is fully extended. Lightly
lubricate the exposed part of the cable.
0006000
(1)
Figure 8
1 – Extended Steering Cable
Description
Where Used
Urea Grease Water
Resistant Type,
NLGI #2
Steering Cable
MAINTENANCE
44
ZT350 Operation Manual
© 2008 Yanmar Marine International
