![background image](http://html1.mh-extra.com/html/yamato/gas410/gas410_instruction-manual_3142218015.webp)
13
4. Operating procedures
Preparations
(
GAS410
)
(3) Install the included connecting tube with M4×10 truss screws.
Connect the hose from the outlet on the cyclone to the connecting tube you have installed.
(4) Connect the ADL311S and the GAS410.
A: Use the hose to connect the heater inlet with filter outlet, and then connect the filter inlet with
GAS410.
Put an O-ring and securely fix using a clamp for installation.
B: Connect the flexible duct into the connecting tube to the duct connecting (inlet) port of GAS410.
Put an O-ring and securely fix using a clamp for installation.
C: Connect a Fluororubber tube (milky white) and fix it using a wire clamp.
D: Connect a tetrone braided hose and fix it using a wire clamp.
E: Connect a tetrone braided hose to the N
2
gas supply unit and fix it using a wire clamp.
F: Connect an interface cable.
G: Connect an interface cable.
H: Set GF300 to the main unit according to the operation manual of ADL311S. Note, however, the
outlet of the cyclone for the connecting hose.
A
B
C
D
F
G
E
Not used
Exhaust hose is
connected here
Not used when
GAS410 is
connected
H