7 - 69
CHAS
EB704101
REMOVING THE HANDLEBARS
1. Stand the motorcycle on a level surface.
WARNING
WARNING
Securely support the motorcycle so that
there is no danger of it falling over.
2. Remove:
• handlebar grip
NOTE:
Blow compressed air between the left
handlebar and the handlebar grip, and
gradually push the grip off the handle-
bar.
EB704401
CHECKING THE HANDLEBARS
1. Check:
• left handlebar
• right handlebar
Bends/cracks/damage
→
Replace.
WARNING
WARNING
Do not attempt to straighten bent han-
dlebars as this may dangerously
weaken them.
EB704704
INSTALLING THE HANDLEBARS
1. Install:
• brake master cylinder holder
1
ACHTUNG:
CAUTION:
• Install the brake master cylinder
holder with the “UP” mark facing up.
• First, tighten the upper bolt, then the
lower bolt.
NOTE:
• Align the mating surfaces of the brake
master cylinder holder with the punch
mark
a
in the right handlebar.
• There should be 2 mm of clearance
between the right handlebar switch
and the brake master cylinder holder.
UP
UP
UP
a
a
1
1
T
R
.
.
13 Nm (1.3 m · kg, 9.4 ft · lb)
HANDLEBARS
Summary of Contents for YZF-R7
