Yamaha WaveRunner VX 700, Service Manual

Page: 145 / 181

8-4
1
2
3
4
5
6
7
8
9
A
Throttle cable removal
1. Remove the corrugated tube
1
.
2. Remove the throttle cable
2
. NOTICE:
Make sure to remove the throttle cable
seal
a
.
Handlebar check
1. Check the handlebar. Replace if bent,
cracked, or damaged.
Left handlebar switch assy. check
1. Check the left handlebar switch assy.
Replace if cracked or damaged.
TIP:
To check the continuity of the left handlebar
switch assy. See “Left handlebar switch
assy.” (7-10).
Handlebar assy. installation
After installing the handlebar assy., make
sure that the throttle cable and left han-
dlebar switch lead are not pulled when the
handlebar is turned to the right and left.
1. Install the left handlebar switch lead
1
into the opening
a
in the grommet
2
,
and then install the throttle cable
3
into
the opening
a
.
TIP:
Face the chamfered end
b
of the grommet
2
down, with the opening
a
facing forward.
2. Install the grommet 2 into the steering
master 4 .
TIP:
Push the grommet 2 into the steering master
4 until it is installed securely.
3. Install the handlebar
5
and upper han-
dlebar holders
6
, and then tighten the
bolts
7
to the specified torque.
1
2
a
b
3
1
2
a
2
2
3
1
4
4
7
6
5
4
1
3
Left handlebar switch assy. and throttle lever assy.