TRBL
SHTG
Troubleshooting
9-1
Engine unit troubleshooting
TIP:
• Before troubleshooting the engine unit, make sure that fresh fuel of the specified type has been
used.
• Check that all wiring connections are properly secured and that they are not rusty or corroded.
• Check that the engine shut-off cord is connected to the engine shut-off switch.
• Check that the battery is charged and that its specific gravity is within specification.
Troubleshooting (engine unit, jet pump unit, charging system)
Symptom 1: Specific trouble conditions
Symptom 2: Trouble conditions of an area or individual part
Cause: The content considered as the trouble factors for symptom 2
—: Not applicable
Symptom 1: Engine does not crank.
Symptom 2
Cause
Checking step
See
page
Starter motor does
not operate
Discharged battery
Check the battery voltage and spe-
cific gravity.
Loose connection of bat-
tery terminal
Check the battery cable and termi-
nal for proper connection.
Blown fuse
Check the fuse for continuity
Starter relay malfunction
Check the starter relay.
Engine start switch mal-
function
Check the engine start switch.
(left handlebar switch)
Short, open, or loose con-
nection in starter motor cir-
cuit
Check the wiring harness.
WD
Starter motor malfunction
Disassemble and check the starter
motor.
Stuck piston or crankshaft
Disassemble and check the engine
unit.
Stuck impeller
Disassemble and check the jet
pump unit.
Starter motor oper-
ates, but the engine
does not crank
Starter clutch assy. or fly-
wheel magneto malfunc-
tion
Check the starter clutch assy., fly-
wheel magneto, or Woodruff key.
WD: See the wiring diagram.
Summary of Contents for WaveRunner VX 700
