3. Basic Operation
66
RS7000
Editing Parameter Values
Parameters can generally be edited by using [Knob 1] ~ [Knob 4].
The parameters that can be adjusted by each knob appear immedi-
ately above each knob in each display page.
In some cases a single knob may be assigned to two parameters.
Use the related function button ([F1] ~ [F4]) to switch to the
desired parameter and then edit it as required using the appropri-
ate knob.
When a numeric parameter is to be edited, in some cases the SUB
MODE buttons can be used as a numeric keypad for direct
numeric data entry while the [SHIFT] and related function button
([F1] ~ [F4]) is held. After entering the desired value press the
[EDIT] (ENTER) button to actually enter the value (it will stop
flashing on the display).
(This entry method is not available for all parameters.)
Command Selection and Execution
Command selection and execution is carried out using the [F1] ~
[F4] buttons.
When this is possible the name of the command will appear out-
lined above the function button at the bottom of the display, and
the indicator of the corresponding function button will light.
[Knob 1]
[Knob 2]
[Knob 3]
[Knob 4]
F1
F2
F3
F4
SHIFT
F1
F2
F3
F4
or
or
or
F1
F2
F3
F4
Summary of Contents for RS7000 Ver.1.2
