6D45F11
3-10
9
8
7
6
5
4
3
2
1
3.
Loosen the locknut
1
, remove the clip
2
, and then disconnect the shift cable
joint
3
.
c
C
The shift/throttle cable joint must be
screwed in a minimum of 8.0 mm (0.31 in)
a
a
.
4.
Adjust the position of the shift cable joint
until its hole is aligned with the set pin
4
on the shift lever.
5.
Install the clip and then tighten the lock-
nut.
6.
Loosen the locknut
5
and adjust the
length of the throttle cable
6
until the
stopper
7
on the pully contacts the stop-
per plate
b
on the bracket. And then
tighten the locknut.
Checking the engine idle speed
1.
Start the engine and warm it up for 5 min-
utes.
2.
Attach the special service tool to spark
plug wire #1
1
, then check the engine
idle speed. Adjust if out of specification.
3.
Turn the throttle stop screw
2
in direc-
tion
a
or
b
until the specified engine idle
speed is obtained.
NOTE:
9
To increase the idle speed, turn the throttle
stop screw in direction
a
.
9
To decrease the idle speed, turn the throttle
stop screw in direction
b
.
4.
After adjusting the idle speed, rev the
engine a few times and let it idle for at
least 15 seconds to check the stability of
the engine.
Control system
3
1
6D430235
2
4
6D430236
b
7
5
6D430228
6
6D430150
1
6D430161
a
b
2
Digital tachometer: 90890-06760
Engine idle speed:
900–1,000 r/min
6D45F11-03 03.10.9 20:43 Page 11
